Huawei R100030G1 - Input Specifications; Output Specifications

7.3 Input
Table 7-3 Input
Item Specications
Input voltage 260–485 V AC (rated voltage: 380 V AC)
Voltage system Three-phase four-wire (3W+PE)
Frequency 40–70 Hz; rated frequency: 50 Hz/60 Hz
Input current ≤ 60 A
Power factor ≥ 0.98 (load ≥ 50%)
THD ≤ 5% (load ratio ≥ 50%)
7.4 Output
Table 7-4 Output
Item
Specications
Output voltage ● Low-voltage mode: 200–506 V DC
● High-voltage mode: 200–1000 V DC (Performance
indicators are not assessed if the voltage is below 400
V in high-voltage mode.)
Rated output current High-voltage mode: 30 A
Output power Rated power: 30 kW
● When the voltage ranges from the power conversion
point to 260 V AC, the output is linearly derated from
full load to half load.
● When the voltage ranges from the power conversion
point to 485 V AC, the charging module outputs at
full load.
(Power conversion point range: 303–323 V AC)
Output current
limiting range
Maximum: 100 A
Soft start time 3–8s
Hibernation function Supported
Standby power
consumption
≤ 9.3 W (tested average power consumption under 380
V AC rated input voltage at 25°C)
R100030G1 Charging Module
User Manual 7 Technical Specications
Issue 05 (2021-11-16) Copyright © Huawei Digital Power Technologies Co., Ltd. 42