The server can be installed with one or two SD cards, which are monitored by the
iBMC. If the iBMC detects two SD cards when completing initialization, the iBMC
automatically congures the two SD cards as a RAID 1 array. You can view
information about the SD cards and RAID 1 array on the iBMC WebUI by choosing
System Info > Other. However, you cannot modify the conguration. The two SD
cards in the RAID 1 array are mirrored with each other. If the SD card to be
installed contains data, data overwriting will occur. Therefore, before installing an
SD card, ensure that the SD card contains no data.
Procedure
Step 1 Wear an ESD wrist strap. For details, see 1 Safety Instructions.
Step 2 Determine the SD card to be replaced. Figure 7-130 shows the positions of the
two SD cards. SD card 1 is above the SD card board, and SD card 2 is below the
SD card board.
Figure 7-130 SD card position
Step 3 Remove the SD card to be replaced. For details, see 7.51 Removing an SD Card.
Step 4 Take the spare SD card out of its ESD bag.
Ensure that the spare microSD card contains no data.
Step 5 If SD card 2 needs to be installed, remove the SD card board rst. For details, see
7.51 Removing an SD Card.
RH2288H V3 Server
User Guide 7 Replacing Parts
Issue 46 (2022-12-28) Copyright © Huawei Technologies Co., Ltd. 264
To Next Page
Loading...
