Huawei RH2288H V3 - Internal Cabling; Internal Cabling for an M.2 SSD Riser Card

13 BMC USB 2.0 connector (J34) 14 System battery
15 Rear hard disk backplane power
connector 1 (J28 PWR CONN2)
16 Jumper (J36)
NOTE
COM_SW pins are used for
changing the serial port
direction, and CLR_BMC_PW pins
are used for restoring the default
iBMC settings.
17 RAID controller card (J44) 18 LCD panel connector (J56)
19 Fan 4 connector (J130) 20 Right mounting ear connector
(J43)
21 Fan 3 connector (J131) 22 Fan 2 connector (J132)
23 Fan 1 connector (J133) 24 Onboard USB 3.0 connector
(J53)
25 Hard disk backplane power
connector (J30 PWR CONN1)
26 Hard disk backplane signal
connector (J1003)
27 Left mounting ear connector (J42) 28 SATA/SATADOM 1 (J37)
29 SATA/SATADOM 2 (J38) 30 PSU backplane connector
(J31)
31 Rear disk backplane power
connector 2 (J29 PWR CONN3)
32 TPM (J35)
33 SoftRAID key (J51) 34 NC-SI connector (J1008)
35 Dual-SD module (J57 SD BOARD) 36 Riser card 2 connector
(corresponding to CPU 2, J3-
J1005)
2.7 Internal Cabling
This section describes the internal cabling for an RH2288H V3 with dierent
congurations.
NO TE
This section uses a RAID controller card on the mainboard as an example to describe how
to connect cables to the card. The method for connecting cables to a standard RAID
controller card is the same as that for connecting cables to a RAID controller card on the
mainboard.
2.7.1 Internal Cabling for an M.2 SSD Riser Card
Internal Cabling for an M.2 SSD Riser Card on a Server with a DVD Drive
For an RH2288H V3 with a DVD drive, an M.2 SSD riser card can be
congured
with only one M.2 SATA SSD card, which uses the external SATA2 port.
RH2288H V3 Server
User Guide 2 Overview
Issue 46 (2022-12-28) Copyright © Huawei Technologies Co., Ltd. 39