Scenarios
Remove the indicator board interface module if it has failed.
Prerequisites
Conditions
● You have powered
o the RH8100 V3. For details, see 6.2 Powering O the
RH8100 V3. Then you have removed all power cables from the server.
● You have removed the DVD drive+LCD module from the RH8100 V3. For
details, see 5.3.1 Removing a DVD Drive+LCD Module.
● You have removed the indicator board. For details, see 5.4.1 Removing the
Indicator Board.
Data
● You have obtained the cabinet number and chassis number of the RH8100 V3.
● You have located the RH8100 V3 based on the preceding information, and
labeled its panel to prevent misoperations.
● You have determined the position on the RH8100 V3 for removing the
indicator board interface module.
Tools
● ESD gloves
● Packaging materials, for example, an ESD bag
● M3 Phillips screwdriver
Procedure
Step 1 Wear an ESD wrist strap or ESD gloves. For details, see 1 Safety Instructions.
Step 2 Open the latch that secures the indicator board interface module. See step (1) in
Figure 5-31.
Step 3 Gently pull out the indicator board interface module. See step (2) in Figure 5-31.
RH8100 V3 Server
User Guide 5 Removing and Installing Parts of the RH8100 V3
Issue 30 (2019-12-19) Copyright © Huawei Technologies Co., Ltd. 145
To Next Page
Loading...
