Figure 5-32 Removing an indicator board interface module
Step 6 Place the removed interface module in an ESD bag.
----End
5.4.4 Installing an Indicator Board Interface Module
This topic describes how to install an indicator board interface module.
Scenarios
Install an indicator board interface module if the original one has failed.
Prerequisites
Conditions
● You have powered
o the RH8100 V3. For details, see 6.2 Powering O the
RH8100 V3. Then you have removed all power cables from the server.
● You have removed the DVD drive+LCD module from the RH8100 V3. For
details, see 5.3.1 Removing a DVD Drive+LCD Module.
● You have removed the indicator board. For details, see 5.4.1 Removing the
Indicator Board.
Data
● You have obtained the cabinet number and chassis number of the RH8100 V3.
● You have located the RH8100 V3 based on the preceding information, and
labeled its panel to prevent misoperations.
RH8100 V3 Server
User Guide 5 Removing and Installing Parts of the RH8100 V3
Issue 30 (2019-12-19) Copyright © Huawei Technologies Co., Ltd. 147
To Next Page
Loading...
