User Manual
SmartAX MT800 ADSL CPE
Chapter 2 Introduction
2-5
RJ11
Tel C a b le
Phone Jack
MT800
10/100Base-TX
Cable
RJ11
Tel C a b le
Phone
pc
Figure 2-4 Computer to MT800 Connection
2.2.3 Connecting Ethernet LAN to MT800
MT800 may be connected to any 10/100Base-TX Ethernet port.
When connecting MT800 to any Ethernet device that is capable of
operating at speeds higher than 10Mbps, be sure that the device has
auto-negotiation mode enabled for the connecting port.
Use cross-over cable to connect MT800 and the uplink port of a
switch or hub. Be sure that the cable connecting the LAN to MT800
does not exceed 100 meters.
2.2.4 Powering On MT800
1) Use the provided power adapter and plugs it into a suitable
power source nearby.
To Next Page
Loading...
