User Manual
SmartAX MT800 ADSL CPE
Chapter 4 Web-based Management
4-24
initiated; the state changes to active when packets are
being exchanged, or closed when the exchange is
complete. TCP connections in the half-open state can use
up the available IP sessions. If the percentage is exceeded,
then the half-open sessions will be closed and replaced
with new sessions as they are initiated.
z
Max ICMP Connection: Sets the percentage of
concurrent IP sessions that can be used for ICMP
messages. If the percentage is exceeded, then older ICMP
IP sessions will be replaced by new sessions as they are
initiated.
z
Max Single Host Connection: Sets the percentage of
concurrent IP session that can originate from a single
computer. This percentage should take into account the
number of hosts on the LAN.
z
Log Destination: Specifies how attempted violations of
the firewall settings will be tracked. Records of such events
can be sent via Ethernet to be handled by a system utility
Ethernet to (Trace) or can e-mailed to specified
administrators.
z
E-mail ID of Admin 1/2/3: Specifies the e-mail addresses
of the administrators who should receive notices of any
attempted firewall violations. Type the addresses in
standard Internet e-mail address format. The e-mail
message will contain the time of the violation, the source
address of the computer responsible for the violation, the
destination IP address, the protocol being used, the source
and destination ports, and the number of violations
occurring in the previous 30 minutes. If the ICMP protocol
To Next Page
Loading...
