User Manual
SmartAX MT800 ADSL CPE
Chapter 5 Service Configuration
5-8
Step 5. Select a PVC and fill the corresponding fields with the
values that provided by ISP or system provider, which include the
value of VPI and VCI.
Step 6. After enter the proper value, please click the Submit
button under the field to submit the setting to ADSL terminal.
Step 7. Leave the ADSL Mode as default value. If your ISP
instructs you to change the ADSL settings, please follow the detailed
setting procedures in Section 4.4 ADSL Mode Configuration.
Step 8. Leave the LAN IP Address as the default value
192.168.1.1, and Subnet Mask as 255.255.255.0. If you want to
modify the LAN IP configuration, please follow the detailed setting
procedures in Section 4.5 LAN Configuration.
Step 9. Usually to leave the NAT Mode as default setting
Enable. For more detailed settings, please refer to the Section 4.9
NAT Configuration.
Step 10. The default setting of DHCP is None. You should
configure the PC’s IP address as the same subnet with the LAN IP of
MT800. If you need to configure the MT800 as DHCP Server mode,
please select DHCP Server option. You should configure the IP
setting of computer in the LAN as to obtain an IP address
automatically. If you need to configure the mode as DHCP Relay,
please select DHCP Relay option, and enter the DHCP Server
address that provided by ISP. At the same time, you should configure
the IP setting of computer in the LAN as to obtain an IP address
automatically. In the case of DHCP Relay, you should disable NAT
function.
To Next Page
Loading...
