Procedure
Step 1 Crimp the OT terminal.
● Pay attention not to damage the core wire when stripping a cable.
● The cavity formed after crimping the conductor strip of the OT terminal needs
to wrap the core wire completely. The core wire needs to contact the OT
terminal closely.
● Wrap the wire crimping area with the heat shrink tubing or the PVC insulation
tape. The following
gure uses the heat shrink tubing as an example.
● When using the heat gun, protect devices from being scorched.
Figure 5-2 Crimping an OT terminal
(1) Cable (2) Core wire (3) Heat shrink tubing
(4) OT terminal (5) Crimping tool (6) Heat gun
Step 2 Connect the PE cable.
SUN2000-(8KTL-20KTL)-M2
User Manual 5 Electrical Connections
Issue 11 (2023-02-07) Copyright © Huawei Technologies Co., Ltd. 43
To Next Page
Loading...
