Huawei SUN2000-150KTL-S0 - Installing Cables Between the SUN2000-150 KTL-S0 and the Isolation Transformer

PowerCube 5000 (SUN2000-150KTL-S0)
Installation Guide
7 Installing Cables
Issue 03 (2020-04-10)
Copyright © Huawei Technologies Co., Ltd.
55
Figure 7-11 Installing the parallel EPO control cable
After startup, press the emergency stop buttons in cabinets 1 and 2. The two cabinets should stop.
----End
7.4 Installing Cables Between the SUN2000-150KTL-S0
and the Isolation Transformer
Procedure
Step 1 Install surge protection, high-temperature, and overtemperature alarm signal cables between
the SUN2000-150KTL-S0 and the isolation transformer.