Step 12 Install the server. For details, see 5.4.3 Installing the Server on Guide Rails.
Step 13 Connect the power cables. For details, see 5.7 PSU.
Step 14 Power on the server. For details, see 5.4.1 Powering On the Server.
Step 15 Log in to the iBMC WebUI, and check whether the new component is normal. For
details, see the
TaiShan Rack Server iBMC User Guide
.
----End
5.12 PCIe Card on a Riser Module
Removing a PCIe Card from a Riser Module
Step 1 Wear an ESD wrist strap. For details, see 5.2 ESD Protection.
Step 2 Power
o the server. For details, see 5.4.2 Powering O the Server.
Step 3 Remove the power cables. For details, see 5.7 PSU.
Step 4 Remove the server. For details, see 5.4.4 Removing the Server and Guide Rails.
Step 5 Remove the chassis cover. For details, see 5.8 Chassis Cover.
Step 6 Remove the riser module where the PCIe card to be removed resides. For details,
see 5.11 Riser Module.
Step 7 Open the PCIe card latch. See (1) in Figure 5-55.
Figure 5-55 Removing a PCIe card from a riser module
Step 8 Pull out the PCIe card. See (2) in Figure 5-55.
Step 9 Place the removed PCIe card in an ESD bag.
Step 10 If a new PCIe card is not installed immediately, install a
ller panel. See Figure
5-56.
TaiShan 200 Server
Maintenance and Service Guide (Model 2280) 5 Removal and Installation
Issue 04 (2020-01-16) Copyright © Huawei Technologies Co., Ltd. 119
To Next Page
Loading...
