Huawei TaiShan 200 2280 - Right Mounting Ear Plate

Step 10 Connect the power cables. For details, see 5.7 PSU.
Step 11 Power on the server. For details, see 5.4.1 Powering On the Server.
Step 12 Power on the server and check that the indicator on the left mounting ear
indicates no fault. For details about the indicator location and status, see 2.2
Front Panel Indicators and Buttons.
----End
5.21 Right Mounting Ear Plate
Removing the Right Mounting Ear Plate
Step 1 Wear an ESD wrist strap. For details, see 5.2 ESD Protection.
Step 2 Power
o the server. For details, see 5.4.2 Powering O the Server.
Step 3 Remove the power cables. For details, see 5.7 PSU.
Step 4 Remove the server. For details, see 5.4.4 Removing the Server and Guide Rails.
Step 5 Use a
at-head screwdriver to pry up the right mounting ear, hold the right
mounting ear, and gently pull it out. See (1) and (2) in Figure 5-92.
TaiShan 200 Server
Maintenance and Service Guide (Model 2280) 5 Removal and Installation
Issue 04 (2020-01-16) Copyright © Huawei Technologies Co., Ltd. 150