Figure 8-16 Position of the jumper
c. Connect the power cables and power on the server.
Step 2 Use a serial cable to connect the terminal serial port and the server serial port.
Step 3 Open HyperTerminal and set the following parameters:
● Bits per second: 115200
● Data bits: 8
● Parity: None
● Stop bits: 1
● Flow control: None
Figure 8-17 shows the port settings.
TaiShan 200 Server (Model 2280)
User Guide 8 Common Operations (iBMC V250 or Later)
Issue 09 (2021-01-12) Copyright © Huawei Technologies Co., Ltd. 138
To Next Page
Loading...
