SSH supports the AES128-CTR, AES192-CTR, and AES256-CTR encryption algorithms.
When you log in to the iBMC over SSH, select a proper encryption algorithm.
Step 1 Download an SSH communication tool to a local client.
Step 2 Connect the client to the server management network port directly or through a
network.
Step 3 Set the client IP address so that the client can communicate with the server iBMC
management network port.
Step 4 On the client, open the SSH tool and set related parameters, such as the IP
address.
Step 5 Connect to the iBMC and enter the user name and password.
● Local and LDAP users can both log in to the iBMC CLI over SSH.
● To log in to the iBMC, LDAP users do not need to enter information about the domain
server, which is automatically assigned by the system.
----End
Logging In over the Serial Port
Step 1 Set the serial port as the iBMC serial port.
● To set the serial port through the iBMC CLI, do as follows:
a. Log in to the iBMC CLI over SSH.
b. Run the following command to change the serial port direction:
ipmcset -d serialdir -v
<option>
TaiShan 200 Server (Model 2280)
User Guide 9 Common Operations (iBMC V3.01.00.00 or Later)
Issue 09 (2021-01-12) Copyright © Huawei Technologies Co., Ltd. 158
To Next Page
Loading...
