Huawei V100R006C00 - Page 125

The interface view is displayed.
3. Run:
poe power maximum-power
The maximum output power of the interface is set.
By default, the maximum output power of an interface is 30000 mW.
Step 3 Optional: Set the power supply priority of an interface.
1. Run:
system-view
The system view is displayed.
2. Run:
interface interface-type interface-number
The interface view is displayed.
3. Run:
poe priority { critical | high | low }
The power supply priority of the interface is set.
By default, the power supply priority of an interface is low.
The priorities in descending order are critical, high, and low.
Step 4 Optional: (Optional) Set the power-off time range of a PoE interface.
1. Run:
system-view
The system view is displayed.
2. Run:
time-range time-name { start-time to end-time days | from time1 date1 [ to
time2 date2 ] }
The power-off time range of a PoE interface is set.
3. Run:
interface interface-type interface-number
The interface view is displayed.
4. Run:
poe power-off time-range time-range-name
The power-off time range takes effect on the interface.
Step 5 Optional: Enable an interface to check compatibility of PDs.
NOTE
Before enabling an interface to check compatibility of PDs, you must enable PoE on the PSE. After this
function is enabled, the interface can detect the PDs that do not comply with IEEE 802.3af.
1. Run:
system-view
The system view is displayed.
2. Run:
interface interface-type interface-number
Quidway S5700 Series Ethernet Switches
Configuration Guide - Device Management 8 PoE Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
116