Huawei V100R006C00 - Page 128

Data Preparation
To complete the configuration, you need the following data:
l Number of an interface on which PoE is to be enabled
l Maximum power consumption of an interface
Configuration Procedure
1. # Enable PoE on GE 0/0/1 of Switch, and configure the maximum power and the power
supply priority GE 0/0/1.
<Switch> system-view
[Switch] interface gigabitethernet 0/0/1
[Switch-GigabitEthernet0/0/1] poe enable
[Switch-GigabitEthernet0/0/1] poe power 12000
[Switch-GigabitEthernet0/0/1] poe priority critical
[Switch-GigabitEthernet0/0/1] quit
2. # Enable PoE on GE 0/0/2 of Switch, and set the maximum power consumption of GE 0/0/2
to 20000 mW.
[Switch] interface gigabitethernet 0/0/2
[Switch-GigabitEthernet0/0/2] poe enable
[Switch-GigabitEthernet0/0/2] poe power 20000
[Switch-GigabitEthernet0/0/2] quit
3. # Enable PoE on GE 0/0/3 of Switch, and set the maximum power consumption of GE 0/0/3
to 2500 mW.
[Switch] interface gigabitethernet 0/0/3
[Switch-GigabitEthernet0/0/3] poe enable
[Switch-GigabitEthernet0/0/3] poe power 2500
[Switch-GigabitEthernet0/0/3] quit
4. # Configure the power supply management of Switch to be in automatic mode.
[Switch] poe power-management auto
Configuration Files
Configuration file of Switch
#
sysname Switch
#
interface GigabitEthernet0/0/1
poe power 12000
poe priority critical
#
interface GigabitEthernet0/0/2
poe power 20000
#
interface GigabitEthernet0/0/3
poe power 2500
#
interface GigabitEthernet0/0/4
#
return
Quidway S5700 Series Ethernet Switches
Configuration Guide - Device Management 8 PoE Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
119