Huawei V100R006C00 - Restarting the S5700 Immediately

BIOS LOADING ...
Copyright (c) 2008-2010 HUAWEI TECH CO., LTD.
CX22EFFE (Ver124, Jun 9 2010, 17:41:46)
Press Ctrl+B to enter BOOTROM menu ... 0
Press Ctrl+B within two seconds. The system prompts you to enter the password of the advanced
BootROM menu as follows:
The default password is huawei.
password:
BOOTROM MENU
1. Boot with default mode
2. Enter serial submenu
3. Enter startup submenu
4. Enter ethernet submenu
5. Enter filesystem submenu
6. Modify BOOTROM password
7. Reboot
Enter your choice(1-7):
In the advanced BootROM menu, you can choose to upgrade the VRP or specify the VRP version
to be loaded when the S5700 is started.
The BootROM initializes the serial interface and the console interface, decompresses the logical
files on the logical chip and the VRP, and then starts the VRP. The terminal displays information
as follows:
Decompressing Image file ... done
PPI DEV SysInit......OK
Hard system init.................OK
Begin to start the system, please waiting ......
VOS VFS init.....................OK
VOS monitor init.................OK
CFM init advance.................OK
PAT init ........................OK
VOS VFS init hind ...............OK
VRP_Root begin...
VRP_InitializeTask begin...
Init the Device Link.............OK
CFG_PlaneInit begin..............OK
CFM_Init begin...................OK
CLI_CmdInit begin................OK
VRP_RegestAllLINKCmd begin.......OK
create task begin................
task init begin...
Recover configuration...OK!done
Press ENTER to get started.
When the terminal displays the preceding information, the VRP has started. Press Enter to enter
the command line interface (CLI).
10.2 Restarting the S5700 Immediately
This section describes how to restart the S5700 immediately.
Quidway S5700 Series Ethernet Switches
Configuration Guide - Device Management 10 Restarting and Resetting
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
131