You can use the display stack configuration command to check the default stack ID and stack
priority when the stack member starts this time and next time.
<Quidway> display stack configuration
Current slot-id Next slot-id Current Priority Next Priority
---------------- ------------- ---------------------- -------------
0 8 200 200
1 3 150 150
3.6 Configuration Examples
This section provides an example for configuring a stack in a ring topology.
3.6.1 Example for Configuring a Stack in a Ring Topology
Networking Requirements
As shown in Figure 3-5, Switch A, Switch B, Switch C, and Switch D form a stack in a ring
topology. The stack system is automatically created. Switch A functions as the master switch,
whereas Switch B functions as a standby switch. After the active/standby switchover, the MAC
address of the stack system is immediately switched. To avoid updating MAC addresses of the
stack system frequently and wasting system resources, set the MAC address switchover time of
the stack system to 1 minute after the active/standby switchover.
Figure 3-5 Networking of a stack in a ring topology
SwitchA
SwitchC SwitchD
SwitchB
stack link
common link
Configuration Roadmap
The configuration roadmap is as follows:
l Configure the MAC address switchover time of the stack system on the master switch.
Data Preparation
To complete the configuration, you need the following data:
Quidway S5700 Series Ethernet Switches
Configuration Guide - Device Management 3 Stacking
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
37
To Next Page
Loading...
