7.6.2 Configuring Remote VLAN Mirroring
Procedure
l Configure remote VLAN mirroring on the source switch.
NOTE
The mirrored port cannot be added to the RSPAN VLAN.
1. Run:
system-view
The system view is displayed.
2. Run:
vlan vlan-id
An RSPAN VLAN is created and the RSPAN VLAN view is displayed.
3. Run:
mac-address learning disable
The MAC address learning is disabled.
NOTE
If MAC address learning is disabled in the VLAN, other services cannot be configured in the VLAN.
4. Run:
quit
Return to the system view.
5. Run:
observe-port index interface interface-type interface-number [ vlan vlan-
id ]
An observing port is configured, and the RSPAN VLAN is specified.
6. Run:
vlan vlan-id
The RSPAN VLAN view is displayed.
7. Run:
mirroring to observe-port index inbound
Remote VLAN mirroring is configured.
To observe incoming and outgoing packets of multiple VLANs, repeat Step 6 and
Step 7.
l Configure the RSPAN VLAN on the intermediate switch and add interfaces to the RSPAN
VLAN.
The configuration is the same as that for remote port mirroring. For details, see 7.3.2
Configuring Remote Port Mirroring.
l Configure the remote observing port on the destination switch.
Quidway S5700 Series Ethernet Switches
Configuration Guide - Device Management 7 Mirroring
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
78
To Next Page
Loading...
