Huawei V200R001C01 - Page 196

Figure 7-7 RIP route sending troubleshooting flowchart
Yes
No
No
No
No
No
No
Yes
Yes
Yes
No
No
No
Yes
Yes
Yes
Yes
Yes
No
No
Yes
Yes
Yes
No
No
Yes
Yes
Yes
No
No
Device does not
send partial or all
the routes
Egress is
enabled?
Egress is
normal?
silent-interface
is configured?
Split horizon
is configured?
undo rip output
is configured?
Filtering policy
is configured?
Any other
problems?
Local
interface is
normal?
Seek technical
support
Enable the egress
Ensure the normal
state on the egress
Cancel the silent-
interface command
Cancel the undo rip
output command
Ensure the policy
does not filter out
routes imported by
RIP
If packets are sent to
local interface, ensure
the normal state on
local interface
Interface is enabled
multicast and peer
command is
configured correctly
Is fault
rectified?
Is fault
rectified?
Is fault
rectified?
Is fault
rectified?
Is fault
rectified?
Is fault
rectified?
Is fault
rectified?
End
Troubleshooting Procedure
Huawei AR2200-S Series Enterprise Routers
Troubleshooting 7 IP Forwarding and Routing
Issue 01 (2012-01-06) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
187