<RouterA> display bridge information
Bridge 1 :
Status : Undo Shutdown
Bridging : IP, Others
Routing : IP
MAC learning : Enable
interface :total 2 interface(s) in the bridge
Ethernet1/0/0 : Up
Ethernet2/0/0 : Up
Bridge 2 :
Status : Undo Shutdown
Bridging : IP, Others
Routing : IP
MAC learning : Enable
interface :total 1 interface(s) in the bridge
Ethernet2/0/1 : Up
l If the bridge group does not have any member interfaces, add physical interfaces to the
bridge group as shown in Figure 4-7.
For details on how to add physical interface to a bridge group, see the chapter "Transparent
Bridge Configuration" in the AR2200-S Configuration Guide - LAN.
l If the bridge group has member interfaces, go to Step 2.
Step 2 Check that every Bridge-if interface is Up.
Use Router A as an example. Run the display interface bridge-if command on Router A to
check the Bridge-if interface status.
<RouterA> display interface bridge-if
Bridge-if1 current state : UP
Line protocol current state : UP
Last line protocol up time : 2011-01-07 15:13:49 UTC-08:00
Description:HUAWEI, AR Series, Bridge-if1 Interface
Route Port,The Maximum Transmit Unit is 1500
Internet Address is 1.1.1.3/24
IP Sending Frames' Format is PKTFMT_ETHNT_2, Hardware address is 00e0-057a-a000
Physical is BRIDGE-IF
Current system time: 2011-01-07 15:27:12-08:00
Last 300 seconds input rate 0 bits/sec, 0 packets/sec
Last 300 seconds output rate 0 bits/sec, 0 packets/sec
Realtime 24 seconds input rate 0 bits/sec, 0 packets/sec
Realtime 24 seconds output rate 0 bits/sec, 0 packets/sec
Input: 11 packets,0 bytes,
10 unicast,1 broadcast,0 multicast
0 errors,0 drops,0 unknownprotocol
Output:13 packets,0 bytes,
11 unicast,2 broadcast,0 multicast
0 errors,0 drops
Input bandwidth utilization : 0.00%
Output bandwidth utilization : 0.00%
Bridge-if2 current state : UP
Line protocol current state : UP
Last line protocol up time : 2011-01-07 15:25:34 UTC-08:00
Description:HUAWEI, AR Series, Bridge-if2 Interface
Route Port,The Maximum Transmit Unit is 1500
Internet Address is 2.2.2.3/24
IP Sending Frames' Format is PKTFMT_ETHNT_2, Hardware address is 00e0-057a-a000
Physical is BRIDGE-IF
Current system time: 2011-01-07 15:27:12-08:00
Last 300 seconds input rate 0 bits/sec, 0 packets/sec
Last 300 seconds output rate 0 bits/sec, 0 packets/sec
Realtime 0 seconds input rate 0 bits/sec, 0 packets/sec
Realtime 0 seconds output rate 0 bits/sec, 0 packets/sec
Input: 139 packets,0 bytes,
0 unicast,0 broadcast,0 multicast
0 errors,0 drops,0 unknownprotocol
Output:140 packets,0 bytes,
0 unicast,0 broadcast,0 multicast
Huawei AR2200-S Series Enterprise Routers
Troubleshooting 4 LAN
Issue 01 (2012-01-06) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
77
To Next Page
Loading...
