EasyManua.ls Logo

Huawei V200R001C01 - Page 87

Huawei V200R001C01
391 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
0 errors,0 drops
Input bandwidth utilization : 0.00%
Output bandwidth utilization : 0.00%
l If the Bridge-if interface is Down, troubleshoot the member interfaces in the bridge group.
For example, check whether the interface is up and the protocol configuration is correct.
l If the Bridge-if interface is Up, go to Step 3.
Step 3 Check that the routes between different bridge groups are reachable.
Run the Ping command on Router A to check whether different bridge groups can ping each
other successfully.
l If the ping fails, go to Step 4.
l If the ping succeeds, go to Step 5.
Step 4 Check that IP routing is enabled for the bridge group.
Run the display bridge information command on Router A to check information about the
configured bridge group.
<RouterA> display bridge information
Bridge 1 :
Status : Undo Shutdown
Bridging : IP, Others
Routing : IP
MAC learning : Enable
interface :total 2 interface(s) in the bridge
Ethernet1/0/0 : Up
Ethernet2/0/0 : Up
Bridge 2 :
Status : Undo Shutdown
Bridging : IP, Others
Routing : IP
MAC learning : Enable
interface :total 1 interface(s) in the bridge
Ethernet2/0/1 : Up
l If IP routing is not enabled for the bridge group, run the routing ip command in the bridge
group view to enable IP routing.
l If IP routing has been enabled for the bridge group, check whether the IP address is correctly
configured for the Bridge-if interface. For details, see the chapter "The Ping Operation
Fails" in the AR2200-S Troubleshooting - IP Forwarding and Routing.
If different bridge groups still cannot ping each other successfully after the preceding steps are
complete, go to Step 5.
Step 5 Check that the network-side interfaces on Router A and Router B are added to the same bridge
group.
Run the display this command on Router A and Router B to check the configuration on network-
side interfaces.
# Check the network-side interface configuration on Router A.
<RouterA> system-view
[RouterA] interface ethernet2/0/1
[RouterA-Ethernet2/0/1] display this
#
interface Ethernet2/0/1
bridge 2
undo shutdown
#
return
Huawei AR2200-S Series Enterprise Routers
Troubleshooting 4 LAN
Issue 01 (2012-01-06) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
78

Table of Contents

Related product manuals