Quidway NetEngine80
Configuration Guide - Basic Configurations 7 Management of Configuration Files
Issue 04 (2009-12-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7-3
Pre-configuration Tasks
Before managing the configuration files, install the router and start it properly.
Data Preparation
To manage configuration files, you need the following data.
No. Data
1 system software and its file name
2 Configuration file and its name
3 The number of start line from which ling the comparison of the configuration
file begins
Configuration Procedures
You can perform Procedure 1 to Procedure 5 in a random order.
No. Procedure
1 Configuring System Software for a Router to Load
2 Configuring the Configuration File for Router to Load
3 Saving Configuration File
4 Clearing Configuration Files
5 Comparing Configuration Files
6 Checking the Configuration
7.2.2 Configuring System Software for a Router to Load
Do as follows on the router:
Step 1 Run:
startup system-software system-filename [ slave-board ]
The system software for the router to load next time when it starts is configured.
The parameter slave-board is valid only on the router with dual main control boards.
----End
7.2.3 Configuring the Configuration File for Router to Load
Do as follows on the router:
Step 1 Run:
To Next Page
Loading...
