Huawei V300R005 - Configuring the Basic FTP ACL; Checking the Configuration

8 FTP, TFTP and XModem
Quidway NetEngine80
Configuration Guide - Basic Configurations
8-8 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 04 (2009-12-20)
rule [ rule-id ] { deny | permit } [ source { host-name { source-wildcard | 0 } |
source-ip-address { source-wildcard | 0 } | any } | time-range time-name | logging |
fragment ]
*
The ACL rule is configured.
----End
FTP supports only the basic ACL.
8.3.4 Configuring the Basic FTP ACL
Do as follows on the router that serves as the FTP server:
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
ftp acl acl-number
The basic FTP ACL is configured.
----End
8.3.5 Checking the Configuration
Run the following commands to check the preceding configuration.
Action Command
Check the configuration and running
information about the FTP server.
display ftp-server
After configuring the FTP server, run the display ftp-server
command. You can view that the
FTP ACL is 2345.
<Quidway> display ftp-server
FTP server is running
Max user number 5
User count 1
Timeout value(in minute) 30
Acl Number 2345