Quidway NetEngine80
Configuration Guide - Basic Configurations 8 FTP, TFTP and XModem
Issue 04 (2009-12-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
8-17
Step 3 Run:
rule [ rule-id ] { deny | permit } [ source { host-name { source-wildcard | 0 } |
source-ip-address { source-wildcard | 0 } | any } | time-range time-name | logging |
fragment ]
The ACL rule is configured.
----End
TFTP supports only the basic ACL rules.
8.6.3 Configuring the Basic TFTP ACL
Do as follows on the router that serves as the TFTP client:
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
tftp-server acl acl-number
ACL is used to limit the access to the TFTP server.
----End
8.7 Configuring XModem
8.7.1 Establishing the Configuration Task
Applicable Environment
Configure XModem to transfer files through serial interfaces.
Pre-configuration Tasks
Before configuring XModem, complete the following tasks:
z
Powering on the router
z
Connecting the router and the PC through an AUX port or a console port
z
Logging in to the router through the terminal emulation program and specifying the file
path in the terminal emulation program
Data Preparation
To configure XModem, you need the following data.
To Next Page
Loading...
