8 FTP, TFTP and XModem
Quidway NetEngine80
Configuration Guide - Basic Configurations
8-24 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 04 (2009-12-20)
[ftp] get vrpv5r3d031.cc
[ftp] quit
----End
8.8.4 Example for Configuring TFTP
Networking Requirements
As shown in Figure 8-4, the IP address of the TFTP server is 10.111.16.160/24.
Log in to the router from the HyperTerminal and then download the file vrp.cc from the TFTP
server.
Figure 8-4 Networking diagram of configuring TFTP
TFTP Server
Quidw ay PC
10.111.16.160/24
Configuration Roadmap
The configuration roadmap is as follows:
1. Run the TFTP software on the TFTP server
2. Set the position of the source file on the server
3. Use the TFTP command on the Quidway router to download the files
Data Preparation
To complete the configuration, you need the following data:
z
The TFTP software installed on the TFTP server.
z
The path of the source file on the TFTP server.
z
The destination file name and its path on the Quidway router.
Configuration Procedure
Step 1 Start the TFTP server, set its Base Directory as the directory where the vrp.cc file resides.
Figure 8-5 shows the interface.
To Next Page
Loading...
