5 User Management
Quidway NetEngine80
Configuration Guide - Basic Configurations
5-22 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 04 (2009-12-20)
Configuration Procedures
To configure a user interface, complete the following procedures.
No. Procedure
1 Sending Messages to Other User Interfaces
2 Clearing Online User
3 Checking the Configuration
5.5.2 Sending Messages to Other User Interfaces
Do as follows on the router:
Step 1 Run:
send { all | interface-type interface-number | number }
You can enable message sending between user interfaces.
Following the prompt, you can enter the message to be sent. You can press Ctrl+Z or Enter
key to end.
----End
5.5.3 Clearing Online User
Do as follows on the router:
Step 1 Run:
free user-interface { ui-number | ui-type ui-number1 }
Online users are cleared.
Upon the prompts, you can confirm whether to clear designated online users.
----End
5.5.4 Checking the Configuration
Run the following commands to check the previous configuration.
Action Command
Display the usage information of the user interface display users [ all ]
Check the online user
display access-user
To Next Page
Loading...
