What to do if my HUAYUAN ELETRIC ZX7-250 has no output current?
If your HUAYUAN ELETRIC Welding System isn't producing any output current, there are several potential causes. First, check if the fuses have blown and replace them if necessary. Also, verify that the fan is working correctly and that the machine is not overloaded, as this can activate the temperature relay. If the temperature relay is damaged, it should be replaced.
Why does my HUAYUAN ELETRIC ZX7-250 Welding System trip the power switch?
If your HUAYUAN ELETRIC Welding System trips the power switch when turned on, it could be due to a damaged three-phase rectifier. In this case, consider replacing the rectifier. Another possible cause is a damaged capacitor that is in parallel with the three-phase rectifier; if this is the case, replace the damaged capacitor.
General| Frequency | 50/60Hz |
|---|---|
| Output Current Range | 20-250A |
| Rated Output Current | 250A |
| Duty Cycle | 60% |
| Efficiency | 85% |
| Insulation Class | F |
| Protection Class | IP21 |
Mandatory reading of the manual and safety precautions before equipment use.
Awareness of arc welding dangers and protection against arc rays.
Procedures to avoid electric shock hazards during operation and maintenance.
Identification and function of controls and indicators on the welding machine panel.
Important safety notes and precautions before performing maintenance.
Common problems, their causes, and recommended solutions for the welding machine.
To Next Page
