41305100055/10/13
Driver Assembly
MAINTENANCE INSTRUCTIONS: Make certain electricity is OFF before beginning maintenance procedures.
1. For opening and closing of the fixture, refer to instructions and diagrams on other side of sheet.
2. A regularly scheduled maintenance program should be established to retain optimum light output and reduce heat
retention. Dusting with a soft, clean, dry cloth is normally sufficient for the Any accumulation of dust or dirt
should be removed regularly from both sides of the lens during maintenance (using ammonia water).
Do not use alkaline
or acid cleaners on reflector surfaces.
!
!
optics.
To Next Page
Need help?
General
