17
9.3.1. Activate the system
Push the „ON/OFF“ button for a few seconds. During this pushing the green LED will
flash.
Release the button when the indication has changed. This time interval is meant to
prevent for unwanted switching.
The system can only be switched on if the throttle is in its zero position. This is an
additional safety device.
Is the throttle not in the zero position, the red LED and green LED will start to flash
after a second. After the throttle is set into its zero position LED 5 will switch off and
the system will be activated.
9.2.2. Deactivate the system
Push the „ON/OFF“ button until all LED’s went off. (aprox. 1 Second).
9.2.3. Adjusting the brightness of the LED’s.
After activating the system the LED’s lighten up bright. The brightness of the LED’s
can be adjusted to your personal requirements. To set the brightness take the next
steps:
Push the „ON/OFF“ button for 0.5 seconds (when the system is already switched on).
While pushing, the LED 1 will flash. The setting will change after releasing the button.
If you push the button shortly, there will no change in brightness. Push again and the
brightness of the LED’s will change.
9.2.4. Switching between the eco and standard mode.
The power support system has two modes of support. The standard- and eco-mode.
(see table). In the eco-mode the motor current is limited. This results in a more
economic use and longer battery life. The default setting after starting up is always
the eco-mode, LED 6 lights up.
To switch to the standard mode you need to push the eco-mode button. LED 6 will
erase and the standard mode is active.
By pushing the eco-mode button again, you can switch back to the eco-mode.
To Next Page