Hunter 30709 - Page 12

41780-01 09/28/2011 12 ©2011 HUNTER FAN CO.
FILTER
To change the lter and reset the Filter Life Counter:
1. First, turn off and unplug the air purier.
2. Next, remove the front grill. Place your ngers under the handle on the grill
and pull forward, then up. Refer to Figs. 4 and 5 (pg. 6).
3. Gently pull on the lter to remove it from the unit. While removing the lter,
note the directional arrows printed on the top of the lter. The new lter will be
installed with the same orientation. Refer to Fig. 10. Once removed, the used
lter can be discarded.
4. Look at the directional arrows printed on the side of the lter. Install the lter
with arrows pointing towards the unit. Refer to Fig. 10. Press the lter rmly
into the air purier. To avoid damaging the lter media, you should press on
the frame of the lter only.
5. Place the front grill back onto the unit. First, line up the tab on the bottom of
the grill with the recess on the purier base and then push the top of the grill
forward until it is closed. Refer to Figs. 6 and 7, pg. 7. NOTE: This unit will
not operate unless the grill is in the correct position.
6. Plug in the unit.
7. To reset the counter to zero hours and turn off the indicator, simply press and
hold the FILTER RESET key for three seconds. Then, you must release the
reset key and then press and hold the lter reset key again for three seconds to
turn off the lter indicator.
Fig. 10