User manual Hunter A2
English (EN) 2 - 5
Svensk (SE) 6 - 9
Suomi (FI) 10 - 13
Norsk (NO) 14 - 17
Dansk (DK) 18 - 21
Deutsch (DE) 22 – 25
Illustration 27 - 28
(EN)
Read the manual carefully before using your hearing protection.
Hunter A2 is an active hearing protector with electronics that reproduces the surrounding sound inside the
hearing protector at a safe level. The sounds are reproduced in stereo to preserve direction location.
This function is intended for use in noisy environments where there is a need to hear the surrounding sound,
such as warning signals, conversation, traffic, etc.
Hunter A2 has individual electronics (separate PCBA for right and left ear).
The hearing protector has been tested and approved according to PPE directive 89/686/EEC and EMC directive
89/336/EEC, which means that it meets the demands for CE marking.
Contents in the package
• Hunter A2 hearing protection
• User Manual
• 2 pcs alkaline battery (1.5V AAA (LR03))
• Opening key to removal of cushion for battery replacement
Inserting and replacing the batteries
The hearing protector is powered by 2x1.5V AAA (LR03) batteries in each ear-cup.
(A:1) Position the opening tool into the jack on the lower part of the ear-cup and turn gently until the cushion
ring separates from the ear-cup & remove the cushion ring and liner.
(A:2) Insert the batteries in the battery holder, ensure they are properly assembled and in the right direction.
(A:3) Reattach the cushion ring and liner by pressing cushion rings against cup until it snaps into place.
Please Note
• It is time to change the batteries when the volume becomes weak.
• When replacing the batteries, the hearing protection should be turned off.
• That the cushion ring is mounted tight against the cup.
• That nothing has been become pinched between the cup and cushion ring.
2
To Next Page
Loading...