USER NOTICE
Excessive room humidity may cause internal water
reservoir to fill up. LED screen will display E5 and
automatically shut off.
Refer to Page 14 of User Manual for draining
instructions.
USER NOTICE
Air Conditioner does NOT display or determine room
humidity. Please use other method to determine
humidity in your home.
USER NOTICE
Always connect drain hose on HEAT MODE or unit will
stop running after water tank is full.
USER NOTICE
Humidity levels cannot be adjusted with the
dehumidification feature and does NOT replace a
dehumidifier. For optimal humidity, we recommend
purchasing a Hunter Dehumidifier.
Your Drain Hose Kit should include a drain hose and clip. Use Primary Drain
Port if used for COOL MODE or HEAT MODE . Use Secondary Drain
Port if used for DRY MODE .
Attaching the Hose :
1. Unplug or disconnect power .
2. Remove drain plug from proper draining port.
3. Attach drain hose and clip to drain plug.
4. Place other end of hose into a drain location. Ensure this end is on a
lower level than end of hose attached to unit. Hose should not be kinked or
pinched .
5. Plug in or reconnect power .
For your convenience, Drain
Hose Kit (HPAC-HOSE) is
available to purchase at
hunterpureair.com or by
calling Customer Service at
(855) 887-1440 .
To Next Page
Loading...
