17
Operation
5. Operation
5.1 Switching the Unit ON
Connect the monitor to the local mains supply. The unit will automatically power
up.
If the unit is in off/standby mode with power already applied, press and hold
for approximately 2 seconds to switch on. A short tone will be heard.
The unit will briefl y display a splash screen, then continue to the Application
Screen.
5.2 Application Screen
The application screen will be displayed and automatically confi gured according
to the options / modules fi tted to the unit. The screen is arranged into a series
of waveforms and numerical indicators. All functions are accessed via the
touchscreen, either through the Control Bar Menus located across the bottom of
the screen or by touching each application.
Note that some applications require you to touch and hold on the relevant area.
Patient Data
Lock/Unlock
Screen
Control Bar
Date/Time
Battery
Status
Alarm
Monitoring Parameters
To Next Page
Loading...