CHARGING YOUR E-SCOOTER
PREPARING YOUR E-SCOOTER
Ensure that the charging port is clean and dry.
Make sure that there is no dust, debris or dirt inside the port.
Connect the cable with the power supply (100V ~ 240V; 50/60 Hz).
The charging indicator light on the charger itself should change to
RED, indicating that your device is now being charged.
When the RED indicator light on your charger turns to GREEN, then
your device is fully charged.
After fully charging your HANG 5 E-scooter, unplug the charger from
your device and from the power outlet.
Plug the charger into a grounded wall outlet.
Align and connect the l-pin charging cable into the charging port of the
HANG 5 E-scooter.(DO NOT FORCE OR BEND THE CHARGING CABLE AS IT
MAY CAUSE THE PRONGS TO BEND OR BREAK.)
CHARGING THE DEVICE
PLEASE READ THE FOLLOWING INSTRUCTIONS CAREFULLY
ATTACHING THE HANDLEBAR KIT
Attach the handle bar kit by placing it into the steering column, align the
front and back screw holes, and tighten the 4 screws into place.
CAUTION
Only use the included charging cable and
charger to charge your E-scooter. Using
any other unauthorized charger may
damage your E-scooter.
WARNING
Any E-scooter that does not work property
can cause you to lose control and fall.
Inspect the entire device thoroughly before
every ride, and do not ride it until any
problems have been corrected.
To Next Page
Loading...
General