Why does my Hurricane Chainsaw smoke so much?
If your Hurricane chainsaw smokes excessively, it might be due to an incorrect fuel mixture. Ensure you are using a properly mixed fuel with a 40:1 mixture.
What to do if my Hurricane HMSE 1235 engine dies?
If your Hurricane chainsaw engine dies, it could be due to an empty petrol tank, so fill it up. Another possibility is that the fuel filter is in the wrong position in the tank; in this case, completely fill the petrol tank or reposition the fuel filter.
Why does my Hurricane HMSE 1235 have poor performance?
If your Hurricane chainsaw has poor performance, it might be because the chain is blunt. Sharpen or replace the chain. Another reason might be a loose chain; in that case, tension the chain.
Why does my Hurricane HMSE 1235 Chainsaw start but has no power?
If your Hurricane chainsaw starts but the engine has low power, check the choke lever position and move it to the correct position. Also, a dirty air filter can cause low power, so remove, clean, and reinstall the filter. For an incorrect carburetor mixture adjustment setting, have it adjusted by an Authorized Service Center.
What to do if Hurricane Chainsaw chain gets hot?
If the cutter rail and chain of your Hurricane chainsaw get hot, it may be due to insufficient chain lubrication. Top up the oil tank for the chain. Also, check the oil lubrication openings and clean the oil entry hole/groove on the guide rail.
Why does my Hurricane HMSE 1235 run erratically?
If your Hurricane chainsaw runs erratically, the cause might be an incorrect carburetor mixture adjustment setting. Have your carburetor adjusted by an Authorized Service Center.
Why does my Hurricane Chainsaw engine hesitate?
If your Hurricane chainsaw engine hesitates, it could be due to an incorrect carburetor mixture adjustment setting. Have the carburetor adjusted by an Authorized Service Center.
What to do if Hurricane HMSE 1235 Chainsaw has no power under load?
If your Hurricane chainsaw has no power under load, the spark plug may be incorrectly gapped. Clean, gap, or replace the plug.
To Next Page
General
