12 SERVICE WORK ON THE CHASSIS 52
12.28 Removing the main silencer
Warning
Danger of burns The exhaust system gets very hot when the vehicle is driven.
– Allow the exhaust system to cool down. Do not touch hot components.
Preparatory work
– Remove the right side cover. ( p. 53)
L00244-11
Main work
– Disconnect spring 1.
– Remove screws 2 and take off the main silencer.
12.29 Installing the main silencer
L00244-10
Main work
– Mount the main silencer. Mount and tighten screws 1.
Guideline
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)
– Reconnect spring 2.
Finishing work
– Install the right side cover. ( p. 54)
12.30 Changing the glass fiber yarn filling of the main silencer x
Warning
Danger of burns The exhaust system gets very hot when the vehicle is driven.
– Allow the exhaust system to cool down. Do not touch hot components.
Info
Over time, the fibers of the glass fiber yarn escape and the damper "burns" out.
Not only is the noise level higher, the performance characteristic changes.
Preparatory work
– Remove the right side cover. ( p. 53)
– Remove the main silencer. ( p. 52)
To Next Page
Loading...
Need help?
General
