How to fix Husar Winches if it does not turn?
If your Husar Winch isn't turning, it's likely due to poor electrical connections. Ensure the Switch Assembly is fully inserted into the connector and tighten all nuts on the cable connections.
What to do if the motor runs but the cable drum does not turn on my Husar Winches?
If the motor of your Husar Winch runs, but the cable drum remains stationary, the clutch might not be engaged. Try turning the clutch to either the high or low-speed position. If the problem persists after this, it's recommended to have a qualified technician inspect and repair the winch.
Why is my Husar Winches braking malfunctioning?
A Husar Winch braking malfunction can occur if the winch is operating in the wrong direction or if the brake slice is worn. To resolve this, change the winch's working direction to clockwise, viewing it from the motor end. Additionally, readjust the braking angle or replace the brake slice.
What to do if Husar Winches drum runs slowly?
If your Husar Winches drum runs slowly, it may be due to insufficient pressure or oil flow, or insufficient fluid in the system. You should check the fluid level and add fluid until it is full. Also, the bump may be unsuitable or defective, so consider changing it for a new or more suitable one.
Why is Husar Winches working direction in backwards?
If the working direction of your Husar Winches is backward relative to the switch assembly, the electrical connections in the valve solenoid are likely in the wrong direction. Correct this by exchanging the blue and yellow wire connectors at the solenoid of the directional valve, or by changing the oil pipe between the valve and motor.
General| Brand | Husar Winch |
|---|---|
| Model | BST H 12000 Lbs |
| Category | Winches |
| Language | English |
To Next Page