Page 103
User Guide v 1.0 — August 2018 Altanium Neo5
9.4.2 Clearing Alarms
If an error occurs, Neo5 will turn on audible and visual alarms and display the alarm condition
on the Alarm screen.
To clear an alarm, do the following:
NOTE: Before resetting an alarm, correct the source of the alarm.
To silence an audible alarm, touch .
To reset the alarm light and acknowledge the alarm, touch .
Touch once and the alarm is assigned the inactive/not acknowledge state.
Touch twice and the alarm is assigned the inactive acknowledge state. This clears the
alarm from the screen. You can see the alarm in the Event History screen after the alarm is
cleared.
9.5 Event History Screen
The Event History screen lists the zone alarms, alarms, warnings, setpoint changes, setup
changes, HMI startup and out of specification events that have occurred previously. On the
Home screen, touch Event History.
NOTE: For a description of the alarm conditions displayed on the Event History screen and
Alarm Summary screen, refer to Section 9.6. For a description of the abort conditions
displayed on the Event History screen and Alarm Summary screen, refer to
Section 9.7.
To Next Page
Loading...
