Husky Altanium Neo5 - Cleaning the System; Mainframe (Cabinet); Touch Monitor

v 1.0 — August 2018 Altanium Neo5
Page 168
15.6 Cleaning the System
15.6.1 Mainframe (Cabinet)
• Use a damp sponge or cloth. No abrasives should ever be used on the surface. The labels
should also be wiped and no cleaners or solvents should be used.
• If a cleaner of any type must be used, a non-ammonia, non-alcohol based glass cleaner
sprayed onto a cloth, not directly onto the cabinet, is recommended.
15.6.2 Touch Monitor
1. Make sure the monitor is turned off.
2. Wipe the screen with a clean, soft, lint-free cloth. This removes dust and other particles.
3. If necessary, apply a small amount of non-ammonia, non-alcohol based glass cleaner
onto a clean, soft, lint-free cloth, and wipe the screen.
WARNING!
Electrical and mechanical hazard - risk of death, serious injury and/or damage to the
equipment. Turn off all power to the system and disconnect it completely from the
main input power.
Hazardous voltages - risk of death or serious injury. Before servicing the Altanium unit
lock-out and tag the Altanium Main Power switch in accordance with local codes.
Use a ground strap when handling the components.
CAUTION!
Mechanical hazard - risk of equipment damage. Do not spray or pour any liquid
directly onto the screen or case. Spray cleaner onto a lint-free cloth. If the liquid
droplets dry on the monitor, the liquid may permanently stain or discolor the monitor.
CAUTION!
Mechanical hazard - risk of equipment damage. The display area is highly prone to
scratching. Do not use ketone type material (e.g. acetone), ethyl alcohol, toluene, ethyl
acid or methyl chloride to clean the panel. These products may permanently damage
the panel and void the warranty.