Husky H6000 - Gearbox Service; Bearings Service; Servicing Intervals

5.01.3
GEARBOX
Refer to section 5.01.1 for
recommended Oil. Use the Maintenance Checklist
provided
to keep a record of all scheduled
maintenance.
I. Do not fill the gear box over 112 full as this will
result in overheating
2. Oil level should be checked daily when in use.
3. There is a vent plug in the side of the box to
relieve the pressure as the oil warms up and expands. It
is possible that some of the oil may push out through
the plug when it is used the first time
4. It is normal [or the box to run quite warm when
working, if it should get vcry hot check the oil
immediately and stop until it cools down
FIG. 4 GEARBOX
5.01.4
BEARINGS
I. The bearing on the bollom of the H5000/H6000
liquid manure pump
is called a marine bearing and it is
lubricated with the manure itself. this bearing needs no
attention. When the pump is out of the pit and in
transport position you can check the bearing wear by
lifting on the fan at the bOllom, if the fan moves over
il2 "/12.7mm
it is time to change the bearing. (See
changing
the bearing in section 5.02.4 of this manual).
2. The bearing in the centre of the pump is an oil
impregnated wooden block . it docs not usually need
replacing
as it just keeps the shaft from whipping at
high speeds. If the bearing is worn 112 "1l2.7mm It is
time to change the bearing. (See changing the bearing
in section 5.02.4 of this manual)
5.01.5
SERVICING
INTERVALS
8 HOURS
OR DAILY
I. Grease PTO Knuckles
2. Grease PTO Drive Knuckle below Gearbox
3. Grease PTO Shield.
4. Check Gear Box Oil Daily.
HOURS BETWEEN SERVICING
~ ~ ?
I r I
I •
~--r-Li
~ ~ -
Ir~- -=-~~~~l
li~-~ ~--lJ§iL_J
FIG. 5
PTO DRIVELINE
SERVICING
ANNUALLY
1. Pull PTO apart grease telescope.
2. Grease PTO Shield.
3. Change Oil in Gearbox
If
the Husky H5000!H6000 pump is
used properly It should give many years of service.
When
worn parts are needed always call your dealer or
the factory and get original parts.
PAGE 16