Husky HV09000 - Vac Assembly and Hose Insertion

6
1. Line up vacuum port above drum
label.
2. Place lid on top of drum with the
handles snug against the drum
channel.
3. Be sure lid completely covers the top
of the drum so leakage does not
occur.
4. Make sure that the locking tabs are
snapped in place to prevent the lid
from coming off (see insert).
Wet/Dry Vac Assembly
Insert Hose
Insert the larger end of the hose into the
vacuum port.
Place the utility nozzle securely on the
opposite end of the hose and the vac is
ready for use.
Powerhead
Flexible
Locking Tab
Push Down
and Pull Out
Flexible
Locking Tab
(located
under latch)
Drum
Channel
Vacuum Port
Drum
Flexible Locking
Tab Pulled Out
Replacement Filter Assembly (continued)
3. Place the float over the opening in the
center of the lid with the words "This
Side Towards Lid" laying face down
over the hole.
4. Line up filter cage tabs with slots in the
center ring of the lid.
5. Push on the filter cage until the tabs
snap into slots for a secure fit.
F
ilter
Cage
T
abs (3)
Slots
(
3)
Power
Assembly
THIS SIDE
TOWARD LID
Filter
Cage
Tabs (3)
Float
Solid End
Slots (3)
SP6688-2 HUSKY-ES.qxd 7/24/08 9:02 AM Page 6