Husky K40068 - Assembly and Operation; Attaching Lamp Head to Stand; Adjusting Light Direction; Turning the Lamp Head On

4
Assembly
1
Attaching the lamp head to the stand
□ Lay the lamp head (A) face down and position the stand (B)
against the U-shaped bracket on the lamp head (A).
□ Attach the lamp head (A) to the stand (B) by inserting the
screw (AA) into the bottom of the stand (B) and through the
U-shaped portion of the lamp head (A). Secure together using
the nut (BB).
B
A
AA
BB
Operation
1
Adjusting the light direction
□ To adjust the lamp head (A), loosen the twist knobs (1) on each
side of the lamp head (A). Then hold the top of the lamp head
(A) and move forward or backward to the desired position.
Retighten the twist knobs (1).
□ To swivel the lamp head (A), loosen the nut (BB) that attaches
the lamp head (A) to the stand (B) and swivel the lamp head
(A) to the desired position. Re-tighten the nut (BB).
A
B
BB
1
2
Turning the lamp head on
NOTE: Plug the worklight into a 120V outlet before you turn
it on.
□ Press the On/Off switch (1) on the lamp (A) to turn the lamp on
( — ) and off ( O ).
A
1