Husqvarna 917.289560/YTH2348 - Page 19

19
SERVICE AND ADJUSTMENTS
02995
S
T
A
Fig. 19
02996
D
FIG. 21
02965
02051
A
NOTE: Be sure mower side suspension arms (A) are pointing
forward before sliding mower under tractor.
• Slide mower under tractor until it is centered under
tractor.
•
FIRST INSTALL ANTI-SWAY BAR (S).
- From right side of mower, insert anti-sway bar into
hole in transmission bracket (T).
FIG. 20
- Pivot bar towards you and insert other end of bar
into hole in rear mower bracket (D). Move mower
as needed to insert bar.
-
Secure with washer and retainer spring as shown
• ATTACH MOWER SIDE SUSPENSION ARMS (A) TO
CHASSIS - P
osition hole in arm over pin (B) on outside
of tractor chassis and secure with washer and retainer
spring.
• Repeat on opposite side of tractor.
FIG. 22
A
B
• ATTACH REAR LIFT LINKS (C) - Lift rear corner of
mower and position slot in link assembly over pin on
rear mower bracket (D) and secure with washer and
retainer spring.
• Repeat on opposite side of tractor.
FIG. 23
D
C