To Next PageTo Next Page
Need help?Do you have a question about the Husqvarna 917.374421 and is the answer not in the manual?
General| Engine | Briggs & Stratton |
|---|---|
| Engine Displacement | 190cc |
| Cutting Width | 22 inches |
| Drive System | Rear-Wheel Drive |
| Deck Material | Steel |
| Fuel Capacity | 1.6 quarts |
| Cutting Height | 1.5 - 4 inches |
| Oil Capacity | 20 oz |
| Mulching Capability | Yes |
| Bagging Capability | Yes |
| Side Discharge Capability | Yes |
| Wheel Size | 8-inch front, 12-inch rear |
Handle gasoline with extreme care due to flammability and explosive vapors.
Steps to safely remove the lawn mower from its shipping carton.
Instructions for unfolding the handle and adjusting it for operator comfort.
Identifies and explains the function of key controls like the operator presence bar and primer.
Engine speed is factory set; operator presence control is mandatory.
How to engage self-propelling, adjust speed, and stop forward motion.
Procedure to raise or lower wheels for desired cutting height.
Instructions for converting between mulching, bagging, and discharging modes.
Procedure for adding the correct amount of oil before the initial engine start.
Instructions for filling the fuel tank with unleaded gasoline.
Steps for starting a cold/warm engine and for stopping the engine.
A table outlining regular checks and services before/after each use, hourly, and seasonally.
Guidance on sharpening, replacing blades, and safety precautions.
Details API service classification, viscosity grades, and oil change procedure.
How to prevent gum deposits and damage by properly preparing the fuel system.
Lists common causes and corrections for engine starting failures.
Addresses issues like mower dragging, dirty filter, and uneven cutting.
Covers excessive vibration, hard-to-pull starter rope, and bent parts.
Solutions for grass catcher not filling and problems with drive speed.
