MAINTENANCE
Husqvarna-37
General
Remove the ignition key to prevent unintentional
movements during lubrication. When lubricating with
an oil can, it must be lled with engine oil.
When lubricating with grease, unless otherwise stated,
use a high grade molybdenum disulphide grease.
For daily use, the machine should be lubricated twice
weekly. Wipe away excess grease after lubrication.
12/12 Every year
1/52 Every Week
1/365 Every day
Lubricate with grease gun
Oil change
Filter change
Lubricate with oil can
Level check
8062-018
It is important to avoid getting lubricant on the belts
or the drive surfaces on the belt pulleys. Should this
happen, attempt to clean them with spirits. If the belt
continues to slip after cleaning, it must be replaced.
Gasoline or other petroleum products must not be
used to clean belts.
25h1/365 50h1/52 200h 300h100h12/12
To Next Page
Loading...
