104 - English
6. TROUBLE SHOOTING
Front loop sensor defect The cabling to the front loop sensor is
defective or has come loose.
Check the levels for Af and Ar via Tools -Test -Loop
(shortcut 5-2-4). Switch between Af and Ar with the
help of Arrow up. When Af is 0 and Ar is higher than
70 (the mower is outside the charging plate, but inside
the loop) or when Quality is lower than 100%, the
cabling to the front loop sensor is defective or has
come loose.
The front loop sensor card is defective. Check the levels for Af and Ar via Tools - Test -Loop
(shortcut 5-2-4). Switch between Af and Ar with the
help of Arrow up. When Af is 0 and Ar is higher than
70 (the mower is outside the charging plate, but inside
the loop) or when Quality is lower than 100% and the
cabling to the front loop sensor is undamaged, it is the
front loop sensor card that is defective and must be
replaced.
Rear loop sensor defect The cabling to the rear loop sensor is
defective or has come loose.
Check the levels for Af and Ar via Tools - Test - Loop
(shortcut 5-2-4). Switch between Af and Ar with the
help of Arrow up. When Ar is 0 and Af is higher than
70 (the mower is outside the charging plate, but inside
the loop) or when Quality is lower than 100%, the
cabling to the rear loop sensor is defective or has
come loose.
The rear loop sensor card is defective. Check the levels for Af and Ar via Tools - Test - Loop
(shortcut 5-2-4). Switch between Af and Ar with the
help of Arrow up. When Ar is 0 and Af is higher than
70 (the mower is outside the charging plate, but inside
the loop) or when Quality is lower than 100% and the
cabling to the rear loop sensor is undamaged, it is the
rear loop sensor card that is defective and must be
replaced.
Trapped The Automower has become caught in
something.
Free the Automower and rectify the reason for it
becoming trapped.
Both, or one of, the rear screws on the
body has not been tightened correctly.
Lift the body from the rear section and feel whether it
is secured correctly. If not, tighten the screws.
The magnet in the collision sensor pillar is
loose, twisted or missing.
Check the collision sensors via Tools - Test - Sensors
(shortcut 5-2-5). Check whether the magnets on the
mower, without contact, indicate a collision.
The collision sensor card or the cabling is
defective.
Check the collision sensors via
Tools - Tes
t - Sensors
(shortcut 5-2-5). Check the collision se
nsors and the
cabling to see whether the magnet is seated correctly
and that the mower, without contact, indicates a
collision.
Upside down The Automower has been lifted or has
turned over and the tilt sensor has
tripped.
Correct the mower.
The tilt sensor is defective. Check the values for Tilt X and Tilt Y via Tools - Test -
Sensors shortcut 5-2-5). When any value is higher
than 20 or when the mower indicates Upside down:
Calibrate the tilt sensor (shortcut 5-6-3). When no
changes are made the control box is defective and
must be replaced. When the fault recurs within a
month after calibration, the control box is defective
and must be replaced.
Table 8: Fault messages
Fault message Cause Action
To Next Page
Loading...
