Automower from 93
4. Autocheck, Service program
™
Settings: Loop detection
On some occasions you may need to turn off a
mower’s loop detection for a little while. This may be
when an Automower needs to be demonstrated when
a charging station and boundary wire have not been
installed, i.e. at a customer’s home.
NOTE! Remember to reactive loop detection again.
To deactivate loop detection:
1. Deselect the Loop detection checkbox.
2. Click on Present in the Change program box.
To activate loop detection again:
1. Select the Loop detection checkbox.
2. Click on Present in the Change program box.
Settings: Demo mode
In order to make it easier to demonstrate an
Automower it is equipped with a demo mode. You can
use different settings in the different programs for
Demo mode.
To activate demo mode:
1. Select the Demo mode checkbox.
2. Click on Present or the appropriate Program
button in the Change program box.
When the function is activated the Automower works
without starting the blade disc. The mower varies
running with charging at four minute intervals.
Settings: Reset
Click on Factory settings to restore all settings on
the mower to the original values. To view these
settings, see
Table 7: Factory settings on page 40. All
settings except the selected language and PIN code
are reset.
3012-590
To Next Page
Loading...
Need help?
General
