English-47
MAINTENANCE
1
2
3
4
5
Blade replacement:
• Remove
blade bolt by turning
counterclockwise.
• Install new or re-sharpened blade with
stamped "GRASS SIDE" facing towards
ground/grass (down) or “THIS SIDE UP”
facing deck and cutter housing.
Some blades may not be stamped with
“GRASS SIDE” and “THIS SIDE UP”.
These blades can be installed either way.
• Install and tighten blade bolt securely.
Tunnel Deck - Torque blade bolt to 90 ft/
lbs (122 Nm).
Combi Deck - Torque blade bolt to 57-61
ft/lbs (77-82 Nm).
WARNING!
Blades are sharp. Protect your
hands with gloves and/or wrap
blades with a heavy cloth when
handling.
IMPORTANT INFORMATION
Special blade bolt is heat treated.
Replace with a Husqvarna bolt if required.
Do not use lower grade hardware than
specified.
11
8011-671
1. Blade
2. Center hole
3. Cutter housing
4. Blade bolt (special)
5. Lockwasher
Blade attachment, principal
To Next Page
Loading...
