Husqvarna P 520D - Lamp Replacement Procedures; Replacing Low Beam and Parking Lamps; Replacing Turn Signal Lamps

English – 27
Propulsion
Assembling
6
5
3
8
9
10
1
2
7
11
4
8095-334
1. Front bearing
2. PTO shaft
3. Sleeve
4. Key
5. Solenoid clutch
6. Rear storage bearing
7. Screw, 114 Nm
8. Washers
9. Screw, 114 Nm
10. Belt pulley
11. Axle
The illustration above shows assembling the
solenoid clutch in section.
1. Slide the solenoid clutch (1) half way onto the
shaft (2).
2. Then put in place the key (3). Use hand power.
Make sure the key is positioned correctly and
that the solenoid clutch subsequently falls easily
in place.
8095-316
3 4
2
1
1. Solenoid clutch
2. Axle
3. Key - half way
4. Key in place